MARINE VEHICLE CHARACTERIZATION AND IMPLEMENTING VARIOUS LEVELS OF AUTONOMY
Date
2024
Authors
Contributor
Advisor
Department
Instructor
Depositor
Speaker
Researcher
Consultant
Interviewer
Narrator
Transcriber
Annotator
Journal Title
Journal ISSN
Volume Title
Publisher
Volume
Number/Issue
Starting Page
Ending Page
Alternative Title
Abstract
Remotely operated vehicles (ROVs) are marine submersible robots that serve a variety of purposes in industry and research. These unmanned vessels harness human judgment and precision to perform tasks within extreme environments like the deep sea, polar, and volcanic regions of the ocean. Some examples of their usages are to survey the ocean floor, maintain pipelines and collect scientific data in the form of sediment and hydrothermal vent plume samples and optical observations of marine wildlife. Training of ROV pilots is typically very expensive and time-consuming because of the highly specialized skill requirements. A novel system was proposed by collaborators from the University of Florida (UF) and the University of Hawai‘i at M ̄anoa (UHM) for piloting ROVs with an intuitive augmented/virtual reality (AR/VR) interface that uses a hybrid autopilot. To demonstrate the feasibility of this system the group at UHM altered the ArduSub firmware of the commercially available BlueROV2 (BROV2) Heavy to enable model-based quantitative control. Error feedback control for the hybrid autopilot was implemented using Robot Operating System (ROS) in a modular manner that enabled various levels of autonomy to assist ROV pilots. Alongside the development of the custom firmware and hybrid autopilot, the software-in-the-loop (SITL) simulation environment was also updated with an experimentally determined hydrodynamic model using onboard sensor- based system identification techniques As much as sixty percent improvement of relative error when predicting vehicle behavior compared to the original SITL model. The calibration process of the hybrid autopilot involved iteratively cycling between SITL and water tank testing. It was demonstrated that this procedure was an effective method for achieving precision control of the BROV2.
Description
Keywords
Robotics, Ocean engineering, Mechanical engineering, Control, Marine Robotics, Remotely Operated Vehicle (ROV), Robot Operating System (ROS), System Identification, Unmanned Underwater Vehicle (UUV)
Citation
Extent
91 pages
Format
Geographic Location
Time Period
Related To
Related To (URI)
Table of Contents
Rights
All UHM dissertations and theses are protected by copyright. They may be viewed from this source for any purpose, but reproduction or distribution in any format is prohibited without written permission from the copyright owner.
Rights Holder
Local Contexts
Collections
Email libraryada-l@lists.hawaii.edu if you need this content in ADA-compliant format.