Please use this identifier to cite or link to this item:
|Title:||WRRCSR No. 9:19:86 Rotating Biological Contactor Pilot Study: Fort Kamehameha Wastewater Treatment Plant, Pearl Harbor, Hawaii|
|Authors:||Dugan, Gordon L.|
Takiguchi, Dean K.
|LC Subject Headings:||Sewage -- Purification -- Hawaii -- Oahu.|
Sewage -- Purification -- Rotating disc process.
Pearl Harbor (Hawaii)
|Publisher:||Water Resources Research Center, University of Hawaii at Manoa|
|Citation:||Dugan GL, Takiguchi DK. Rotating biological contactor pilot study: Fort Kamehameha wastewater treatment plant, Pearl Harbor, Hawaii. Honolulu (HI): Water Resources Research Center, University of Hawai'I at Manoa. WRRC special report, 9:19:86.|
|Series/Report no.:||WRRC Special Report|
|Abstract:||A self-contained pilot unit (including primary and secondary sedimentation) complete with electric motor driven plastic discs (surface area approximately 500 ft2), located at the U.S. Navy's 7.5 mgd Fort Kamehameha Wastewater Treatment Plant (WWTP) at Pearl Harbor, O‘ahu, Hawaii, was operated from July 1985 to July 1986 at four different operating modes: hydraulic loadings of 1.5, 3.0, and 5.0 gpd/ft2 (flat disc area) with discs exposed; and 5.0 gpd/ft2 with discs covered. The influent for the RBC unit was primary clarifier effluent, which was very brackish for wastewater (4000-5000 mg/l chloride). In addition, wastewater from industrial-type operations that use and discharge controlled/treated concentrations of heavy metals were received at the WWTP. The median effluent BCDs concentrations for the first two hydraulic loading rates (1.5 and 3.0 gpd/ft2) were respectively 2.0 and 8.0 mg/l, with corresponding respective median suspended solids values of 8.0 and 7.5 mg/l. These values were comparable with the present WWTP operation utilizing the activated sludge process. Hydraulic loadings at 5.0 gpd/ft2 provided median effluent BOD5 concentrations in the 30 to 35 mg/l range. Heavy metal concentrations in the wastewater flows of the WWTP and RBC unit were considerably below the level of concern, while some accumulation of heavy metals was noted for the higher concentrations of suspended and settled solids--the mixed liquor suspended solids and the raw and digested sludge. Replacing the existing activated sludge component with an RBC component being hydraulically loaded at 3.0 gpd/ft2 would require an estimated capital cost of approximately $2,500,000, which would require nearly 20 years to repay in electrical cost savings, based on a 10¢/kWh electrical cost, that increases in cost at an annual rate of 5%, and an interest rate of 8% compounded annually.|
|Sponsor:||Contract N62742-84-C-0152; Navy Public Works Center, U.S. Department of the Navy, Pacific Division, Naval Facilities Engineering Command, Pearl Harbor|
|Pages/Duration:||vi + 85 pages|
|Appears in Collections:||WRRC Special Reports|
Items in ScholarSpace are protected by copyright, with all rights reserved, unless otherwise indicated.